Software Bisque Knowledge Base Article – 110

“ERROR CODE=11” ADDING SET POINT TO HORIZON/LIMIT

ISSUE

When using the Telescope, Horizon Editor, Set Point command to add a point to either Horizon Line or Altitude Limit Line, error message displayed:
“Error :Error Code=11”

RESOLUTION

The point which the user is attempting to add is outside the acceptable range. The range is as follows:

Horizon Line: 0 through +45 altitude.
Altitude Limit: +45 through +90 altitude.
Dec Limit: -90 through +90 declination.

APPLIES TO

Reference Lines

KEYWORDS

SBKB

This article was formerly published under the identifier Q234KB in Software Bisque’s prior knowledge base.

Last Reviewed: 11/24/2004