› Forums › Knowledge Base › Knowledge Base Articles › 249 – INSTALLING RAS FROM CD-ROM GIVES SCRIPT ERROR 503

Viewing 1 post (of 1 total)
  • Author
  • August 23, 2005 at 2:00 pm #88177

    admin
    Participant

      Software Bisque Knowledge Base Article – 249

      INSTALLING RAS FROM CD-ROM GIVES SCRIPT ERROR 503

      ISSUE

      During installation of RAS from a CD-ROM, the installation program reports an error at script line 503. The installation then exits.

      RESOLUTION

      The 16-bit RAS on early RASClient CD-ROMs cannot be installed directly from the CD-ROM.

      The files from the Disk001-005 folders must be copied to a single folder on the hard disk, then install.exe can be run from there.

      APPLIES TO

      Installation

      KEYWORDS

      SBKB

      This article was formerly published under the identifier Q488KB in Software Bisque’s prior knowledge base.

      Last Reviewed: 11/24/2004

    • Author
      Posts
    Viewing 1 post (of 1 total)
    • The forum ‘Knowledge Base Articles’ is closed to new topics and replies.